Gnimu-CAN
Gnimu-CAN reads vehicle data from a car’s CAN bus and streams it over Bluetooth Low Energy (BLE) at a fixed rate, for telemetry apps to record alongside GNSS and IMU data. It is a companion to Gnimu, and its first target app is AutoX Data Logger, which reads it as a custom BLE sensor.
Work in progress. Gnimu-CAN has been tested on the bench and with AutoX Data Logger, but not yet in a car. Nothing has been released, and anything here may change.
What it does
- Finds the car’s CAN bit rate and discovers the engine computer.
- Polls standard OBD-II values, RPM and throttle position to start, so it should work on most cars from 2008 on. Vehicle-specific versions will come later.
- Streams them, with the supply voltage, in Gnimu protocol frames.
- Sleeps when the car is parked or its battery is low, and wakes on a timer to check whether to resume.
Hardware
Gnimu-CAN runs on a Seeed XIAO ESP32C6 with an Adafruit CAN Pal transceiver, on one of the Gnimu-CAN carrier boards, connected to the car through a small OBD-II helper board. See the PCB page for the boards and their status.
Use at your own risk
Gnimu-CAN connects to your car’s diagnostic port and transmits on its CAN bus. It is a personal project, not a product: it has not been tested on any car other than the author’s, and it comes with no warranty. Read the use at your own risk section of the README before you connect one to a car.